Turning Off The Machine; Machine Settings; Setting The Water Hardness - Smeg BCC01 User Manual

Customisation of the amount of
dispensed Americano drink: the
drink is produced by dispensing
espresso coffee followed by hot
water. To customise this drink,
proceed as with other drinks and
stop dispensing both coffee and,
next, hot water.
Any customization of the drinks
remains saved for future dispensing.
To restore the manufacturer's settings,
press the keys (9)
simultaneously for at least
3 seconds.
The machine emits a single sound to
signal the restoration of the factory
settings.

Turning off the machine

• Check that the drip tray (14) is positioned
correctly.
• If there is no water, the machine remains in
the rinse position until the tank is filled.
• Press the button (9)
(18), (19) light up flashing in sequence and
the machine, if it has dispensed at least one
coffee, performs a self-cleaning cycle.
At the end of the self-cleaning cycle, the
machine switches off.

MACHINE SETTINGS

(Fig. C-G)
Through a programming menu it is possible
to set the water hardness and the acoustic
signals.
Use
and (20)
, the keys (16), (17),
Activation / deactivation of acoustic
signals
The acoustic signals can be disabled /
enabled by keeping the keys (17)
(20) pressed for three seconds; the key
(17) flashes three times indicating the
memorization of the setting.

Setting the water hardness

To access the water hardness programming,
press the keys (16)
simultaneously for at least 3 seconds, the
LEDs (21) , (22)
up flashing.
• Choose the water hardness, referring to the
following table, pressing the key (16)
, the LED relating to the selected hardness
lights up steadily, the others go off.
Led Hardness
Light
21
Medium
22
Hard
23
• To memorize the selected hardness,
press keys (16)
simultaneously for at least 3 seconds or do
not press any key for 15 seconds.
To prolong the machine operation
and preserve the aroma and taste of
the coffee, it is recommended to use
the Smeg Softener Filter (optional,
not supplied). For installation and
operation, follow the instructions
that accompany the accessory.
Once installed, set the water
hardness level to 'Light' following
the instructions in the previous
paragraph.
and
and (20)
, (23) light
and (20)
EN - 7