Sealing The Cable Holes - Huawei APM30H Installation Manual

6 Sealing the Cable Holes

a
Sealing the Cable Holes in the
The cable module for the IBBS200D, IBBS200T, or APM30H
When two IBBS200Ds or two IBBS200Ts are installed in sta
cabinet is not required.
Lead the cable through the cable hole with an aperture matchi
sealing is effective. li i ff ti
b
Sealing the Cable Holes in the
1 Cl 1. Close the cable holes on both th bl h l
sides and at the rear of the base.
Baffle plate
Baffle piece
3. Install the front panel on the front o
Ch Check whether the paint on the cabinet surface is damaged k h th th i t
page 34.
The PVC corrugated pipe is recommended for the cable led
b th
Baffle plate
th bi t f i d
e Cabinets
H is the same as that for the TMC11H.
ck mode, the installation of the cable module in the upper
ing the cross-sectional area of the cable in order that the
e Base
2. Seal the cable holes with fireproof
clay.
Fireproof clay
The fireproof clay can be used to seal the cable holes
of the base. It cannot be used to seal the cable holes
of the cabinet.
of the base.
d d If th d. If the paint is damaged, repair the damaged paint, read i t i d d
d out of the cabinet.
2 6
Fireproof
clay
Fireproof
clay
PVC corrugated
pipe
i th d d i t d