Table of Contents
Advertisement
Quick Reference Guide
To clear an active alarm, press OFF button on control panel, then ENTER button, and finally AUTO button. If alarm
reoccurs, contact an IASD.
Active Alarm
LED
FLASHING
NONE
GREEN
HIGH
RED
TEMPERATURE
OVERLOAD
RED
REMOVE LOAD
RPM SENSE
RED
LOSS
NOT ACTIVATED
NONE
NONE
GREEN
LOW OIL
RED
PRESSURE
RPM SENSE
RED
LOSS
OVERCRANK
RED
LOW VOLTS
RED
REMOVE LOAD
OVERSPEED
RED
UNDERVOLTAGE
RED
UNDERSPEED
RED
STEPPER
RED
OVERCURRENT
WIRING ERROR
RED
Owner's Manual for Australian 3-Phase 50 Hz Air-Cooled Generator Sets
Problem
Unit running in AUTO but
no power in house.
Unit shuts down during
operation.
Unit shuts down during
operation.
•
Unit was running and
shut down, attempts
to restart.
•
Incorrect pressure in
fuel field kit.
Unit will not start in
AUTO with utility loss.
Unit will not start in
Check screen for start
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
•
Unit will not start in
AUTO with utility loss.
•
Incorrect pressure in
fuel field kit.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Unit will not start in
AUTO with utility loss.
Troubleshooting/Quick Reference Guide
Action
Check generator set
Check generator set MLCB (generator set
MLCB (generator set
disconnect). If it is ON, contact an IASD.
disconnect).
Inspect ventilation around generator set,
Check LEDs / screen
intake, exhaust, and rear of unit. If no
for alarms.
obstructions are present, contact an IASD.
Check LEDs / screen
Clear alarm and remove household loads
for alarms.
from generator set. Put in AUTO and restart.
•
Clear alarm and remove household loads
from generator set. Put into AUTO and
restart.
Check LEDs / screen
for alarms.
•
Check fuel field kit pressures switches. If
generator set does not start, contact an
IASD.
Check if screen says
See Activation in installation manual.
unit not activated.
If startup delay is greater than expected,
contact an IASD to adjust from 2 to 1500
delay countdown.
seconds.
Check LEDs / screen
Check oil level and add oil as needed. If oil
for alarms.
level is correct, contact an IASD.
Clear alarm. Using control panel, check
battery by navigating to BATTERY MENU
Check LEDs / screen
option from the MAIN MENU. If battery
for alarms.
condition displays GOOD, contact an IASD.
If control panel displays CHECK BATTERY,
replace battery.
Verify fuel line shutoff valve is ON. Clear
Check LEDs / screen
alarm. Start unit in MANUAL. If it does not
for alarms.
start, or starts and runs rough, contact an
IASD.
Check LEDs / screen
Clear alarm and remove household loads
for alarms.
from generator set. Put in AUTO and restart.
Check LEDs / screen
Contact an IASD.
for alarms.
•
Contact an IASD.
Check LEDs / screen
for alarms.
•
Check fuel field kit pressures switches.
Check LEDs / screen
Contact an IASD.
for alarms.
Check LEDs / screen
Contact an IASD.
for alarms.
Check LEDs / screen
Contact an IASD.
for alarms.
Solution
33
Advertisement
Table of Contents
