Generac Power Systems G0072190 Owner's Manual page 2

Use this page to record important information about this generator set.
Model:
Serial:
Prod Date Week:
Volts:
LPV Amps:
NG Amps:
Hz:
Phase:
Controller P/N:
STA MAC ID:
SSID:
ii
Record the information found on the unit data label on this
page. See General Information
label. The unit has a label plate affixed to the inside partition,
to the left of the control panel console as shown in
See Operation for directions on how to open the top lid and
remove the front panel.
Always supply the complete model and serial numbers of the
unit when contacting an Independent Authorized Service
Dealer (IASD) about parts and service.
Operation and Maintenance: Correct maintenance and care
of the unit ensures a minimum number of problems, and
keeps operating expenses at a minimum. It is the operator's
responsibility to perform all safety inspections, to verify all
maintenance for safe operation is performed promptly, and to
have the equipment inspected periodically by an IASD. Nor-
mal maintenance, service, and replacement of parts are the
responsibility of the owner/operator and are not considered
defects in materials or workmanship within the terms of the
warranty. Individual operating habits and usage may contrib-
ute to the need for additional maintenance or service.
NOTE: Service, repairs, and maintenance of the unit must be
performed by an IASD. Authorized service technicians are
factory-trained and capable of handling all service needs. To
locate the nearest IASD, visit the dealer locator at:
erac.com/Service/DealerLocator/
Owner's Manual for Australian 3-Phase 50 Hz Air-Cooled Generator Sets
for the location of unit data
Figure
www.gen-
2-1.