Wash2Dry; Remoteupdate; Running A Remoteupdate - Miele TWJ 660 WP Operating Instructions Manual

Settings

Wash2Dry

You can select the Wash2Dry function
under Further programmes.
Options
-
Off
- On
Wash2Dry is enabled and you will
find this function under Further pro-
grammes.

RemoteUpdate

The RemoteUpdate function is used for
updating the software in your tumble
dryer.
RemoteUpdate is activated by default.
If you do not install a RemoteUpdate,
you can continue to use your tumble
dryer in the usual way. However, Miele
recommends installing RemoteUpdates.
Activation
The RemoteUpdate menu option is
only displayed and can only be selec-
ted if you have added your tumble
dryer to your WiFi network (see
"Miele@home" in the "Settings"
chapter).
Miele's RemoteUpdate function can
only be used if the tumble dryer is con-
nected to a WiFi network and you have
an account in the Miele@mobile app.
The tumble dryer must be registered in
it.
See the Miele@mobile app for terms
and conditions of use.
Some software updates can only be
carried out by Miele Service.
96

Running a RemoteUpdate

If a RemoteUpdate is available for your
tumble dryer, it will be displayed auto-
matically for you.
You can choose to start the RemoteUp-
date immediately or wait until later. If
you select "Start later", the prompt to
run the RemoteUpdate will be displayed
again the next time you switch on your
tumble dryer.
The RemoteUpdate can take a few
minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
a RemoteUpdate is available.
- Once a RemoteUpdate has been in-
stalled, it cannot be undone.
- Do not switch off the tumble dryer
during a RemoteUpdate. Otherwise,
the RemoteUpdate will be aborted
and will not be installed.