Miele TWJ 660 WP Operating Instructions Manual page 61

Heat pump dryer
Hide thumbs Also See for TWJ 660 WP:
Table of Contents

Advertisement

Message
Empty container.
See 
lights up
after a pro-
gramme has
been cancelled
Blockage detected.
lights up
See 
after a pro-
gramme has
been cancelled
 Service Fault F
XXX
lights up
after a pro-
gramme has
been cancelled.
Cause and remedy
The condensed water container is full or there is kink
in the drain hose.
 Empty the condensed water container.
 Check the drain hose.
To switch the fault message off:
 Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
The laundry is unevenly distributed or has rolled up.
 Open the door and loosen the laundry. Remove a
few items if necessary.
 Switch the dryer off and then on again.
 Start a programme.
There is no obvious cause.
 Switch the dryer off and then on again.
 Start a programme.
If the programme terminates again with the same er-
ror message, then there is a fault. Contact Miele.
Problem solving guide
61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents