Preparing For Use - R&S QPS201 Getting Started

®
R&S QPS201

6 Preparing for Use

Installing the R&S QPS requires experience and must be performed by trained person-
nel. For a comprehensive description of the initial installation and configuration of the
R&S QPS, refer to the installation manual.
Once the scanner itself is installed, you can connect the accessories like the operator
touchscreen.
Connecting devices
All required cables are part of the delivery.
Scanner
Secondary Panel
Figure 6-1: Connection overview
The overview shows the connections for HW 3.50. For HW 3.30, the touchscreen is
connected to a wall outlet instead of the primary panel. Otherwise the connections are
the same for both hardware variants.
The connections for the R&S LPS correspond to those of a R&S QPS HW 3.50.
LAN connections
All devices connected to the R&S QPS must be in the same subnet.
Connecting the panels
► Connect the secondary panel to the primary panel.
a) Establish a LAN connection between the two panels.
b) Establish a remote control power connection between the two panels.
Connecting the operator touchscreen
► Connect the operator touchscreen to the primary panel.
Getting Started 1179.3438.02 ─ 02
Primary Panel
LAN
LAN
LAN
LAN
LAN
USB / DisplayPort / Power
AC
AC
LAN +
Remote Power
Mandatory system components
Optional system components
Resolution Resolution
Station 1 Station 2
AC AC
Touchscreen
(operator)
Preparing for Use
Resolution Resolution
Station 3 Station 4
AC AC
Optional:
WTMD metal
detector
AC
14