R&S QPS201 Getting Started page 17

®
R&S QPS201
The panel is supplied with power.
Booting the panel
1. Establish all necessary connections.
2. Supply both panels with power.
3. Press the power button on the side of the primary panel to turn on the complete
system.
The system boots. When done, the operator touchscreen shows the login screen.
4. Log into the system to operate the scanner.
Note: Level 1, 2 and 3 user accounts will be locked after three failed log in
attempts.
Power saving mode
The R&S QPS enters an energy saving mode when it is not used for a while.
Waking up from this mode takes a a few seconds. A corresponding message is dis-
played on the operator touchscreen.
Turning off the system
1. On the touchscreen monitor, enter the home menu.
2. Select the "Shut Down" menu item.
The system shuts down.
3. Turn off the mains power switch (position "0").
The panel is disconnected from the AC power supply.
4. Remove the power cord from the power supply.
Emergency shutdown
In case of an emergency, disconnect the R&S QPS from the power source.
There are several ways to do that.
●
If possible, pull the mains plug from the mains outlet.
●
Turn off the mains power switch of the panels.
Getting Started 1179.3438.02 ─ 02
Preparing for Use
17