Sony Handycam DCR-PC330 Operation Manual page 14

6
Slide the POWER switch up to (CHG)
OFF.
The CHG (charge) lamp lights up and
charging starts.
After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
1
Set the POWER switch to (CHG) OFF.
2
Slide the battery release lever and slide
the battery pack out.
b After removing the battery pack
• Always attach the terminal cover to protect the
battery terminal. If you do not use the battery pack
for a long time, use up the battery pack completely
before storing it. See page 120 about storage of the
battery pack.
14
Getting started
POWER
switch
Battery release
lever
To check the remaining battery – Battery
Info
DISPLAY/BATT INFO
OPEN
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to OFF (CHG).
2
Press OPEN and open the LCD panel.
3
Press DISPLAY/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Possible recording time using the LCD
panel.
C Possible recording time using the
viewfinder.
POWER switch