Table of Contents
Advertisement
PAGE 1 1
INALTO.HOUSE
WATER SUPPLY AND DRAIN CONNECTION CONTINUED
Important! New waste traps typically have the dishwasher spigot sealed off with plastic and requires the plumber
or licensed installer to drill out the center of the spigot to allow water to flow. It's important to ensure this spigot
is drilled out before calling our Service team to respond to a dishwasher failure, as there will be a fee payable
should we attend and find this non-warranty installation fault.
If you do not have a waste trap with the dishwasher spigot, you can also insert the drain hose directly into a drain
pipe, providing it's diameter is a minimum of 4cm. Refer to location B shown in Figure 7.
Figure 7- Shows the correct positioning of the drain hose.
Important! The height of the drain hose must be less than 1000mm at all times, including at its final connection.
If the drain hose is higher at any point, the dishwasher will not be able to drain effectively and will cause a fault
during its operation.
Note. It's critical for the effective operation of your dishwasher, that the waste pipe is not over-bent or kinked
as this will restrict flow and can cause a fault with the dishwasher. When pushing the dishwasher back into it's
housing, take special care to ensure that the waste pipe is not kinked or the dishwasher sitting on the waste pipe.
Note. The end of the drain hose must not be immersed in water to avoid back flow into the dishwasher.
You can also let the drain hose run directly into the sink, ensuring that the waste pipe is not bent or kinked, only
when the sink is lower than the 1000mm maximum height.
Drain hose extensions
If you need to use a drain hose extension, please ensure that your installer uses a similar drain hose. The total
length of drain hose must be no longer than 4 meters, otherwise the cleaning performance of the dishwasher will
be impacted. This will also effect the manufacturer's warranty as a non-compliant installation.
Syphon connection
The waste connection must be at a height less than 1000mm from the bottom of the dishwasher. The water drain
hose connection must be fixed in place.
Hide quick links:
Advertisement
Table of Contents
