Veris Industries H8030 Installation Manual

H8030/8031
Product identification
Model Max Amps
H8030-0100-2 100
H8030-0300-2 300
H8031-0100-2 100
H8031-0300-2 300
Z205220-0C PAGE 1
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
POWER MONITORING
0
CT Size Enhanced Data
Stream Meters
Small
n
n
©2009 Veris Industries USA 800.354.8556 or 503.598.4564 / support@veris.com
INSTALLATION GUIDE
H8030/8031
Modbus Energy Meter
Networked kW/kWh Transducer
Installer's Specifications
Input Primary Voltage
Number of Phases Monitored
Frequency
Maximum Primary Current
Internal Isolation
Case Insulation
Temperature Range
Humidity Range
Accuracy ±1% of reading from 10% to 100% of the CT rated current
(accomplished by matching the CT with the meter and calibrating them as a unit)
Output Physical Characteristics
Baud Rate
Protocol
CT
quick install
Disconnect and lock out power before installation.
1. Choose a Modbus address not currently in use and set this address using the
switches on the bottom of the CT.
2. Connect the voltage leads to the source to be monitored.
3. Snap the CT onto the conductor.
4. Connect the RS-485 wires (observe polarity).
5. Reconnect power.
dimensions
39 mm
1.6"
94 mm
3.7"
208 to 480 VAC Line-to-Line
50/60Hz
100 or 300A cont.
2000VAC RMS
600VAC
0° to 60°C (32° to 140°F)
0 to 95% non-condensing
RS485, 2-wire plus common
Modbus RTU
Split-core, 100 or 300A
120 mm
4.7"
32 mm
1.25"
29 mm
1.2"
107 mm
4.2"
03095
1
9600