Viewing Warning/Fault Information; Qr Code Generation For Mobile Service Application - ABB ACS180 Firmware Manual



Viewing warning/fault information

The drive is able to store a list of the active faults actually causing the drive to trip at
the present time. The drive also stores a list of faults and warnings that have
previously occurred.
For each stored fault, the panel shows the fault code, time and values of nine
parameters (actual signals and status words) stored at the time of the fault. The
values of the parameters for the latest fault are in parameters 05.80...05.88.
For active faults and warnings, see
• Main menu - Diagnostics - Active faults
• Main menu - Diagnostics - Active warnings
• Options menu - Active faults
• Options menu - Active warnings
• parameters in group
For previously occurred faults and warnings, see
• Main menu - Diagnostics - Fault & event log
Note: Active faults are also stored in the fault and event log.
• parameters in group
The event log can also be accessed (and reset) using the Drive composer PC tool.
See Drive composer PC tool user's manual (3AUA0000094606 [English]).

QR Code generation for mobile service application

A QR Code (or a series of QR Codes) can be generated by the drive for display on
the assistant control panel. The QR Code contains drive identification data,
information on the latest events, and values of status and counter parameters. The
code can be read with a mobile device containing the ABB service application, which
then sends the data to ABB for analysis. For more information on the application,
contact your local ABB service representative.
04 Warnings and faults
04 Warnings and faults
(page 112).
(page 112).
Fault tracing 333