ABB ACS180 Firmware Manual page 293

No. Name/Value
99.08 Motor nominal
frequency
0.00...500.00 Hz
99.09 Motor nominal speed
0...30000 rpm
99.10 Motor nominal power
0.00... 10000.00 kW
or 0.00... 13404.83 hp
99.11 Motor nominal cos Φ
0.00...1.00
99.12 Motor nominal torque
0.000...4000000.000
N·m or
0.000...2950248.597
lb·ft
Description
Defines the nominal motor frequency. This setting must
match the value on the rating plate of the motor.
Note: This parameter cannot be changed while the drive
is running.
Nominal frequency of the motor.
Defines the nominal motor speed. The setting must match
the value on the rating plate of the motor.
Note: This parameter cannot be changed while the drive
is running.
Nominal speed of the motor.
Defines the nominal motor power. The setting must match
the value on the rating plate of the motor. If multiple
motors are connected to the drive, enter the total power of
the motors. The unit is selected by parameter
selection.
Note: This parameter cannot be changed while the drive
is running.
Nominal power of the motor.
Defines the cosphi of the motor for a more accurate motor
model. This value is not obligatory, but is useful with an
asynchronous motor, especially when performing a
standstill identification run. With a permanent magnet or
synchronous reluctance motor, this value is not needed.
Notes:
• Do not enter an estimated value. If you do not know the
• exact value, leave the parameter at zero.
• This parameter cannot be changed while the drive is
running.
Cosphi of the motor.
Defines the nominal motor shaft torque for a more
accurate motor model. Not obligatory. The unit is selected
by parameter 96.16 Unit
Note: This parameter cannot be changed while the drive
is running.
Nominal motor torque.
96.16 Unit
selection.
Parameters 293
Default
FbEq 16
50.00 Hz
10 = 1 Hz
1435 rpm
1 = 1 rpm
1.10 kW or
hp
1 = 0.01 unit
(see par.
46.04)
0.00
100 = 1
0.000
N·m or lb·ft
1 = 100 unit