Mechanical Brake Control - ABB ACS180 Firmware Manual

252 Parameters
No. Name/Value
43
44 Mechanical brake
control
44.01 Brake control status
Bit Name
0 Open command
1 Opening torque
request
2 Hold stopped
request
3 Ramp to stopped
4 Enabled
5 Closed
6 Opening
7 Open
8 Closing
9...15 Reserved
0000h...FFFFh
44.06 Brake control enable
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
Supervision 1
Supervision 2
Supervision 3
Supervision 4
Supervision 5
Supervision 6
Other [bit]
Description
Configuration of mechanical brake control.
Displays the mechanical brake control status word.
This parameter is read-only.
Information
Close/open command to brake actuator (0 = close, 1 = open).
Connect this bit to desired output.
1 = Opening torque requested from drive logic
1 = Hold requested from drive logic
1 = Ramping down to zero speed requested from drive logic
1 = Brake control is enabled
1 = Brake control logic in
1 = Brake control logic in
1 = Brake control logic in
1 = Brake control logic in
Mechanical brake control status word.
Activates/deactivates (or selects a source that
activates/deactivates) the mechanical brake control logic.
0 = Brake control inactive
1 = Brake control active
The brake control function is disabled.
The brake control function is enabled.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Bit 0 of 32.01 Supervision status
Bit 1 of 32.01 Supervision status
Bit 2 of 32.01 Supervision
Bit 3 of 32.01 Supervision
Bit 4 of 32.01 Supervision
Bit 5 of 32.01 Supervision
Source selection (see Terms and
BRAKE CLOSED state
BRAKE OPENING state
BRAKE OPEN state
BRAKE CLOSING state
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status.
status.
status.
status.x
abbreviations).
Default
FbEq 16
0000h
1 = 1
Not selected
0
1
2
3
4
5
6
24
25
26
27
28
29
-