Advertisement
Underarm (Axillary) Use:
Wipe armpit with a dry towel. Place the probe in the patient's armpit
(Figure 3) and keep the patient's arm pressed firmly against the
body.
The time required for an accurate underarm temperature may
be 10 seconds or longer depending on placement of the probe and
closure of the arm against the body.
How to Change the Measurement Scale
1.Turn the unit off.
2.Hold Power until the LCD displays either
3.Push the Power button to switch between °F and °C. After two seconds, the unit will set
to the currently displayed scale. When
temperature.
Replacing the Battery
1. When the unit displays "
2. With the unit off, carefully unscrew the battery cover, slide
it off, and remove the old battery (Figure 4).
3. Insert a new LR41 battery with the "+" symbol facing back
of thermometer.
4. Replace the battery cover before turning unit back on.
Error Indications
The measured temperature is above 109.4°F (43°C), LCD displays "Hi."
H
°
F
i
Retake temperature using proper technique.
The measured temperature is below 89.6°F (32°C), LCD displays "Lo."
L o
°
F
Retake temperature using proper technique.
The battery needs to be replaced.
The thermometer was removed before a temperature was taken.
°
- - -
F
Retake temperature.
There is a problem with the thermometer. Please contact your retailer.
E
rr
Cleaning and Disinfecting
Do not use corrosive detergent to clean the unit.
Clean and disinfect the thermometer before and after each use.
Cleaning Process
•
Use of probe covers is recommended to help avoid spreading germs, and to keep the
thermometer clean. The thermometer should be cleaned after use even when probe
covers are used.
•
Wipe probe with a cloth dipped in a disinfectant solution such as 70% isopropyl
(rubbing) alcohol or soap and water.
• Rinse off disinfectant residue.
Care and Storage
• Do NOT drop or crush; this device is not shock proof.
• Do NOT dismantle or modify device.
• Do NOT store the device in an extreme environment with direct sunlight or high
temperatures.
• Store the unit in the protective case while not in use.
Standards
Complies with IEC60601-1:2006, IEC60601-1-2:2007, EN 12470-3:2000 and
ASTM E
1112-00.
Specifications
Measurement Range:
Accuracy:
Display Unit:
Storage Conditions:
Operating Conditions:
Battery:
Battery Life:
Display:
Weight:
Dimensions:
Measurement Time:
Audible Alarm:
Memory:
Auto Off:
The manufacturer recommends verifying the accuracy of the unit by an authorized laboratory every 2 years.
Limited Warranty
This product is warranted against defects in materials and workmanship under normal use and
service as follows:
1. Warranty service extends to the original retail purchaser only and commences with the
date of delivery.
2. Your Adimals digital thermometer is warranted for two years from date of purchase.
What Is Covered: Replacement of parts, and labor.
What Is Not Covered: Transportation charges to Service Center. Batteries where supplied.
Damages caused by abuse, misuse, accident, or negligence. Incidental, special, or consequential
damages. Some states do not allow the exclusion or limitation of incidental, special, or conse-
quential damages, so this limitation may not apply to you.
To Obtain Warranty Service: Send item(s) postage paid to ADC Service Center, 55 Commerce
Dr., Hauppauge, NY 11788. Please include your name and address, phone no., proof of purchase,
and a brief note explaining the problem.
Implied Warranty: Any implied warranty shall be limited in duration to the terms of this warranty
and in no case beyond the original selling price (except where prohibited by law). This warranty
gives you specific legal rights and you may have other rights which vary from state to state.
For Australian Consumers: Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonable foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
EC
REP
Batteries and electronic devices must be disposed
of in accordance with the locally applicable
regulations, not with domestic waste.
Read the instruction manual carefully before using
this device, especially the safety instructions, and
keep the instruction manual for future use.
IB p/n 93-426-00 rev 3 (11/16/21)
", the battery needs to be replaced.
89.6°F ~ 109.4°F (32.0°C ~ 43.0°C)
±0.3°F / 89.6°F ~ 95.7°F (±0.2°C / 32.0°C ~ 35.4°C)
±0.2°F / 95.9°F ~ 107.6°F (±0.1°C / 35.5°C ~ 42.0°C)
±0.3°F / 107.8°F ~ 109.4°F (±0.2°C / 42.1°C ~ 43.0°C)
(When measured at a standard room temperature of 73.4°F (23°C) in the water bath)
0.1°F (0.1°C)
-13°F ~ 158°F (-25°C ~ 70°C) / 15% - 90% RH
50°F ~ 104°F (10°C ~ 40°C) / 15% - 90% RH
1.55V (LR41)
Estimated 4,000 uses
(more than 200 hours of continuous use)
LCD Liquid Crystal Display
0.71 oz (20g) including battery
6.1'' x 1.2'' x .66'' (155.5mm x 32.5mm x 17mm)
Oral, Rectal, Axillary 10 seconds
Notified beeper for ready and finished measurements
The fever alarm will sound with short beeps at 100°F (37.8°C)
Stores last temperature taken
After 1 minute
Geon Corporation
No. 12, Gung Ye Road, Hsi Hu
Chang Hwa Hsien, Taiwan
MYM STC, SL.
Avda. de los Rosales,
32, 28935 Móstoles
Madrid, Spain
or
C
F
Lo
°
is displayed, the unit is ready to take a
F
Distributed by: ADC®
55 Commerce Drive
Hauppauge, NY 11788
Inspected in the U.S.A.
tel: 631-273-9600
toll free: 1-800-232-2670
fax: 631-273-9659
www.adctoday.com
email: info@adctoday.com
Figure 3
.
Figure 4
Made in Taiwan
2460
Printed in Taiwan
Advertisement
