Siemens SIPROTEC 7SS60 Manual page 41

Table 4-1 Extract from the operation structure and illustration of selection of the marshalling blocks
1st level
66
9
3$5$0(
7SS60 Manual
E50417-G1176-C132-A2
the next input, output or LED position. In the display the physical input/output unit
forms the heading.
Key leads to the 5th level, in which the logical functions are actually selected for
assignment. The display shows, in the upper line, the physical input/output unit, this
time with a one to two digit index number. The second display line shows the logical
function which is presently allocated.
2nd level
 32:(5
6<67'$7
 0$56+
On this 5th level all marshallable input and output functions can be paged through after
password input by repeated used of the key +. Backscrolling is possible with the key –.
When the required function appears, press the enter key E. After this, further functions
can be assigned to the same physical input or output module (with further index num-
bers) by using key
selection place is to be assigned to no function, selection is made with the function
QRW DOO (not allocated).
You can leave the selection level by pressing the key
previous selection level. Now you can scroll with key
output module or with
above.
3rd level
 0$56+
%,1,13
:
continue for
marshalling of
signal relays,
LEDs and com-
mand relays
. Each selection must be confirmed by pressing the E key. If a
to the previous one to repeat the selection procedure, as
4th level
 0$56+
%,
 0$56+
%,
 0$56+
%,
. The display shows again the
to the next (physical) input/
Configuration
5th level
%, 
%, 
%, 
%, 
%, 
%, 
4-7