Sharp MD-E9000H Service Manual page 70

MD-E9000H
(2) Tracking system check.
Check the TE waveform at pin 15 on IC1.
If the waveform shown in Figure 70-1 appears and soon after
NO DISC appears ?
No
"Initialization" is possible, but play is not possible ?
No
"Initialization" is not possible.
(3) Spin system check.
Press the OPEN/CLOSE switch without inserting a disc, and
then try starting the play operation.
1. The turntable rotates a little ?
(Waveform drawing Figure 70-2.)
No
2. The turntable doesn't rotate.
All manuals and user guides at all-guides.com
Yes
A normal jump operation cannot be completed or the beginning of
Yes
the track cannot be found.
Check the around pin 20 on IC1.
Data cannot be read. Check the VCO-PLL system.
Yes
– 70 –
The tracking servo is not activated.
Check the peripheral circuits at pins 9 and 10 on IC1, and circuit
around CNP2.
T
Stopped
CH1=10 V CH2=1 V
DC 10:1 DC 10:1
TE
2
DRF
T
1
=Filter= =Offset= =Record Length=
Smoothing : ON CH1 : 0.0 V Main :
BW : FULL CH2 : 0.00 V Zoom :
CH3 : 0.00 V
CH4 : 0.00 V
Figure 70-1
The spin driver circuit is OK.
Check around pin 22 on IC1, pins 20 and 21 on IC2, and around
CNP4.
T
Stopped
CH1=200 mV CH2=500 mV
DC 10:1 DC 10:1
T
FDO
2
SPDO
1
=Filter= =Offset= =Record Length=
Smoothing : ON CH1 : 0.000 V Main :
BW : FULL
CH2 : 0.000 V Zoom :
CH3 : 0.00 V
CH4 : 0.00 V
Figure 70-2
100 ms/div
(100 ms/div)
NORM: 100 kS/s
=Trigger=
100 K Mode : NORMAL
2 K Type : EDGE CH1
Delay : 2.924 ms
0.2 µs
Hold off :
1999/04/07 09:51:15
500 ms/div
(500 ms/div)
NORM: 20 kS/s
=Trigger=
100 K Mode : NORMAL
2 K Type : EDGE CH2
Delay : 2.924 ms
0.2 µs
Hold off :