Caution - Sehan Electools SCOUT II Manual

1) The power is supplied from KT-38D or FT-40D controller to Scout through RJ-11 "A"
screwdriver port. The screwdriver port "A" works for power feeding from the
connected controller KT-38D or FT-40D additionally.
If the screwdriver port "A" is empty (not used), then external power (24VDC, 1A) is
required.
2) Scout II have 4 screwdriver port for direct connecting of KT-38D and FT-40D.
Also one extra screwdriver can be connected through 25P I/O.
3) Cycle can be started by the signal from PLC, sensor or other equipment.
Also Scout gives the cycle complete signal to PLC or other equipment, too through
the 25P I/O port
4) The numeric LED shows the number of screws which should be fastened for a cycle.
5) Power Input (24VDC,1A) is required when the Hybrid screwdriver is connected.
Don't connect both KT-38D (or FT-40D) and HDC controller together to Scout II.
6) Fastening results are displayed by NG or OK for every fastening. In order to use
NG/OK judgment, the different parameter setting can be saved on the program no.
from 1 to 8.
7) Parameter setting is also possible on Scout Manager (pc software). It transmit
the settings to Scout II. The settings on programs can be saved in csv format file.

4. Caution

1) The screw counter SCOUT II should be used with KT-38D or FT-40D controller only.
Never use the screw counter with any other tools not specified by the manufacturer.
It can be dangerous by the electrical shock.
2) Be careful of right connecting cable between the screwdriver controller and Scout II.
3) Never use non specified cable by the manufacturer.
4) Don't connect both KT-38D (or FT-40D) and HDC controller together to Scout II.
5) Do not use the screw counter near fire and magnetic environment.
- 5 -