Mount The Pump - Graco ChemSafe 307 Instructions - Parts Manual

Mount Mount The Mount The Pump The Pump Pump
To avoid serious injury from toxic fluid or fumes:
• Ventilate to a remote area. The pump
exhaust air may contain contaminants. See
Air Exhaust Ventilation, page
• Never move or lift a pump under pressure. If
dropped, the fluid section may rupture. Always
follow the Pressure Relief Procedure, page
before moving or lifting the pump.
• Prolonged exposure to UV radiation will degrade
natural polypropylene components of the pumps.
To prevent potential injury or equipment damage,
do not expose pump or the plastic components
to direct sunlight for prolonged periods.
Accessories/Components Not Accessories/Components Accessories/Components
A Air supply line
B Bleed-type master air valve (required
for your pump)
C Air filter/regulator assembly
D Master air valve (to isolate the
filter/regulator for service)
E Grounded flexible fluid supply line
F Fluid drain valve (required for your
pump)
G Fluid shutoff valve
H Grounded, flexible fluid outlet line
334793E
Tel: 866-777-6060
Fax: 866-777-6383
11.
14,
Not Supplied Not Supplied Supplied
Springer Pumps, LLC
1. Mount the pump so the exhaust port remains
clear of the production area. Exhaust air may
contain debris and condensation from the air
supply and air chamber.
2. Be sure the mounting surface can support the
weight of the pump, hoses, and accessories, as
well as the stress caused during operation.
3. For all mountings, be sure the pump is secured
with screws through the mounting feet. Always
mount the pump upright.
4. Make sure the surface is flat and that the pump
doesn't wobble.
5. For ease of operation and service, mount the
pump so air inlet, fluid inlet and fluid outlet ports
are easily accessible.
System Components System System Components Components
J Air inlet port
K Exhaust port and muffler
L Fluid inlet port
M Fluid outlet port
N Mounting feet
Website: www.springerpumps.com
Installation
9
Int'l: +001 267 404 2910