Graco ChemSafe 307 Instructions - Parts Manual page 4

Warnings
EQUIPMENT MISUSE
EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
THERMAL EXPANSION
THERMAL THERMAL
Fluids subjected to heat in confined spaces, including hoses, can create a rapid rise in pressure
due to the thermal expansion. Over-pressurization can result in equipment rupture and serious
injury.
• Open a valve to relieve the fluid expansion during heating.
• Replace hoses proactively at regular intervals based on your operating conditions.
PLASTIC PARTS
PLASTIC PLASTIC
Many solvents can degrade plastic parts and cause them to fail, which could cause serious
injury or property damage.
• Use only compatible water-based solvents to clean plastic structural or pressure-containing
parts.
• See Technical
solvent manufacturer's MSDSs and recommendations.
4
Tel: 866-777-6060
Fax: 866-777-6383
WARNING WARNING WARNING
MISUSE HAZARD HAZARD
MISUSE HAZARD
Technical Technical Data
EXPANSION HAZARD HAZARD
EXPANSION HAZARD
PARTS CLEANING CLEANING SOLVENT SOLVENT HAZARD
PARTS CLEANING SOLVENT
Technical Data Technical Data Data in this and all other equipment instruction manuals. Read fluid and
Springer Pumps, LLC
Data in all equipment manuals. Data
Pressure Relief Pressure Relief Procedure Relief Procedure when equipment is not in use. Procedure
HAZARD
HAZARD
Technical Data Data
Technical Data
334793E
Website: www.springerpumps.com
Int'l: +001 267 404 2910