Making Cappuccinos And Milk-Based Coffees; Filling And Attaching The Milk Container - DeLonghi DINAMICA plus ECAM37X.70 Instructions For Use Manual

Selected quantity
2. Press "COFFEE POT";
3. Select the aroma and number of cups;
4. Press .
5. After a few seconds, preparation begins automatically and
an image of the selected beverage appears on the display,
together with a progress bar which gradually fills as prepa-
ration progresses.
Once the coffee has been made, the appliance is ready to make
the next beverage.
Please note:
• : press to interrupt preparation completely
and go back to the homepage.
SAFETY WARNING:
After making the pot of coffee, leave the ap-
pliance to cool for 5 minutes before making
another beverage. Risk of overheating!
9. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note!
To avoid milk with poor froth or large bubbles, always clean the
milk container lid (E2) and hot water connection nozzle (A8)
as described in sections "9.4 Cleaning the milk container after
use", "12.10 Cleaning the milk container" and "12.11 Cleaning
the hot water nozzle".

9.1 Filling and attaching the milk container

1. Remove the lid (E2) (fig. 14);
13
Quantity (ml)
250
500
750
14
10
2. Fill the milk container (E3) with a sufficient quantity of milk,
not exceeding the MAX level marked on the container (fig.
15). Each mark on the side of the container corresponds to
about 100 ml of milk;
Please note!
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
• If "Energy Saving" mode is enabled, you may have to wait a
few seconds before the beverage is delivered.
3. Make sure the milk intake tube (E4) is correctly inserted in
the bottom of the milk container lid (fig. 16);
15
4. Place the lid back on the milk container;
5. Remove the hot water spout (D6);
6. Attach the milk container (E) to the connection nozzle (A8)
and push as far as it will go (fig. 17). The machine emits a
beep (if the beep function is enabled);
7. Place a sufficiently large cup under the coffee spouts (A9)
and the frothed milk spout (E5). Adjust the length of the
milk spout. To move it nearer the cup, simply pull it down-
wards (fig. 18).
17
8. Follow the instructions below for each function.
16
18