Introduction; Letters In Brackets; Troubleshooting And Repairs; Description - DeLonghi DINAMICA plus ECAM37X.70 Instructions For Use Manual

1. INTRODUCTION

Thank you for choosing this bean to cup espresso and cappuc-
cino machine.
Take a few minutes to read this Instruction for Use. This will
avoid all risks and damage to the appliance.

1.1 Letters in brackets

The letters in brackets refer to the legend in the description of
the appliance on pages 2-3.

1.2 Troubleshooting and repairs

In the event of problems, first try and resolve them by reading
the information given in sections "17. Displayed messages" and
"18. Troubleshooting".
If this does not resolve the problem or you require further in-
formation, you should consult Customer Services by calling the
number given on the annexed "Customer Service" sheet.
If your country is not among those listed on the sheet, call the
number given in the guarantee. If repairs are required, contact
De'Longhi Customer Services only. The addresses are given in
the guarantee certificate provided with the machine.

2. DESCRIPTION

2.1 Description of the appliance
A1. Beans container lid
A2. Pre-ground coffee funnel lid
A3. Beans container
A4. Pre-ground coffee funnel
A5. Grinding adjustment dial
A6. Cup shelf
A7. button: to turn the appliance on and off (standby)
A8. Hot water connection nozzle
A9. Coffee spouts (adjustable height)
A10. Condensate tray
A11. Coffee grounds container
A12. Cup tray
A13. Drip tray water level indicator
A14. Drip tray grille
A15. Drip tray
A16. Water tank lid
A17. Water tank
A18. Water softener filter housing
A19. Infuser door
A20. Infuser
A21. Power cord connector socket
A22. Main switch
2.2 Description of the homepage (main screen)
(page 3 - B)
B1. Energy Saving active symbol
B2. Selected aroma
B3. Directly selected beverages
B4. Scroll arrow
B5. Quantity selected
B6. Descale required alarm
B7. Milk container needs cleaning alarm
B8. Filter needs replacing alarm
2.3 Description of the control panel
C1.
C2.
C3.
C4.
2.4 Description of the accessories
D1. "Total Hardness Test" indicator paper
D2. Pre-ground coffee measure
D3. Descaler
D4. Water softener filter (certain models only)
D5. Cleaning brush
D6. Hot water spout
(page 2 - A)
D7. Power cord
2.5 Description of the milk container
E1. Froth adjustment and CLEAN dial
E2. Milk container lid
E3. Milk container
E4. Milk intake tube
E5. Frothed milk spout (adjustable)

3. SETTING UP THE APPLIANCE

Please note!
•
•
•
1. Insert the power cable connector (D7) into the socket (A21)
5
: beverage aroma selection
: My beverages selection menu. Unless previous-
ly programmed from the settings menu as described in
chapter "11. Customising the beverages", the beverage is
programmed directly the first time you use the appliance
: appliance settings menu
: beverage quantity selection
The first time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit fills.
Coffee has been used to factory test the appliance and it
is therefore completely normal for there to be traces of
coffee in the mill. The machine is, however, guaranteed to
be new.
You should customise water hardness as soon as possible
following the instructions in section "14. Setting water
hardness".
at the back of the appliance and connect the appliance to
the mains electricity supply (fig. 1). Make sure the main
switch (A22) at the back of the appliance is pressed (fig. 2);
(page 3 - C)
(page 3 - D)
(page 3 - E)