Table of Contents
Advertisement
67
Plug the low-voltage cable of the power supply unit into the 24 V socket on the rear of the TO 7280 (Fig. 29).
Then plug the power supply unit into the mains socket.
The power supply must be placed in an easily accessible position so that the device can be
disconnected from the mains at any time!
The power switch, located on the back of the TO 7280, is used to switch the device on and off. A blue
illuminated operating indicator on the front of the TO 7280 signals the operating state "On".
Fig. 29
2.7
Installation of the TW 7650
The sample changer TW 7650 is connected directly to the oven TO 7280. The further installation is carried out
analogous to section 2.6 Installation of the TO 7280.
For the use of the TW 7680 the PC software TitriSoft is required.
The KF oven/changer is supported from TitriSoft version 3.5.
The connection contacts for the oven are located on the sample changer (Fig. 30).
When connecting the TW 7650, the TO 7280 must be switched off and disconnected from the mains.
Only switch on the TO 7280 after complete installation!
Fig. 30
Advertisement
Table of Contents
