Meritor PreSet Maintenance Manual page 2

Service Notes
About This Manual
This manual provides maintenance and service procedures for
 
PreSet by Meritor hub assemblies.
Before You Begin
1. Read and understand all instructions and procedures before
you begin to service components.
2. Read and observe all Warning and Caution hazard alert
messages in this publication. They provide information that can
help prevent serious personal injury, damage to components,
or both.
3. Follow your company's maintenance and service, installation,
and diagnostics guidelines.
4. Use special tools when required to help avoid serious personal
injury and damage to components.
Hazard Alert Messages and Torque
Symbols
WARNING
A Warning alerts you to an instruction or procedure that you
must follow exactly to avoid serious personal injury and
damage to components.
CAUTION
A Caution alerts you to an instruction or procedure that you
must follow exactly to avoid damage to components.
@
This symbol alerts you to tighten fasteners to a specified torque
value.
How to Obtain Additional Maintenance,
Service and Product Information
Visit Literature on Demand at meritor.com to access and order
additional information.
Contact the OnTrac Customer Service Center at 866-668-7221
(United States and Canada); 001-800-889-1834 (Mexico); or email
OnTrac@meritor.com.
Meritor Maintenance Manual MM-0637 (Revised 07-12)
If Tools and Supplies are Specified in
This Manual
Contact Meritor's Commercial Vehicle Aftermarket at
888-725-9355.
Warranty Information
Refer to brochure SP-95155, Commercial Vehicle Systems
Warranty, for complete warranty information. For instructions to
return warrantable parts to Meritor for reimbursement
consideration, contact Meritor's OnTrac Technical Support Center at
866-668-7221 for assistance.
Information contained in this publication was in effect at the time the publication was
approved for printing and is subject to change without notice or liability. Meritor Heavy
Vehicle Systems, LLC, reserves the right to revise the information presented or to
discontinue the production of parts described at any time.