Drying The Bathroom / 浴室乾燥 - Mitsubishi Electric V-251BW-HK Instruction Manual

Bathroom thermo ventilator
Hide thumbs Also See for V-251BW-HK:
Table of Contents

Advertisement

Drying the Bathroom / 浴室乾燥
Warning
Press to start operation.
按此按鈕開始運轉。
The operation lamp of the main unit lights and drying operation starts.
主機運轉指示燈亮起,乾燥運轉開始。
Press to switch to drying (Wind) mode.
按此按鈕切換到乾燥 ( 風乾燥 )。
The mode toggles between High (warm air)/Low (warm air)/Wind
each time the button is pressed.
每次按下按鈕時,模式會在強(暖風)/弱(暖風)/風乾燥之間切換。
To change the time remaining of OFF timer
The time remaining changes each time
The setting range is from 0.5 to 12 hours.
(Default setting: 4 hours)
* See page 19 for information about using the ON timer.
更改定時關機的剩餘時間
每次按
設定範圍為0.5至12小時。
(預設設定:4小時)
* 有關定時開機的資訊,請參閱第19頁。
To stop the system during OFF timer operation
Press
定時關機運轉時停止系統
* For details, see page 18.
* 有關詳細資料,請參閱第18頁。
11
Do not touch or stand near the outlet during or
immediately after drying or heating operation.
The area around the outlet is hot and could cause burn injuries.
警 告
請勿在乾燥或暖房運轉停止後立即觸摸
Prohibited
出風口或站在附近。
禁止
出風口周圍溫度很高,可能造成燙傷。
時,剩餘時間都會變更。
.
is pressed.

Advertisement

Table of Contents
loading

Table of Contents