Table of Contents
Advertisement
Connect the
the Power
Power Supply
Connect
Connect
the
Power
Improper wiring may cause electric shock or other
serious injury if work is not performed properly.
Have a qualified electrician perform any electrical
work. Be sure your installation complies with all
National, State and Local safety and fire codes.
1. Ensure that the fused safety switch (B) is shut
off and locked out.
Figure 6 Locked Out Fused Safety Switch
2. Install a start/stop control (C) in the electrical
supply line (A), within easy reach of the
equipment. The start/stop control must be
approved for use in hazardous locations.
3. Open the electrical compartment (S) on the
motor.
3A2526L
All manuals and user guides at all-guides.com
Supply
Supply
4. Bring the power wires into the electrical
compartment through the 3/4–14 npt(f) inlet port.
Connect the wires to the terminals, as shown.
Torque the terminal nuts to 15 in-lb (2 N•m)
maximum. Do
Do
Do not
not
not over-torque.
over-torque.
over-torque.
5. Close the electrical compartment. Torque the
cover screws (J) to 15 ft-lb (20 N•m).
Figure 7 Connect the Power Wires
Notes
Notes
Notes for
for Fig.
for
Fig. 7 7 7
Fig.
Tighten all terminal nuts to 15 in-lb (2 N•m)
1
maximum. Do
Do not
Do
not over
not
over- - - torque.
over
Tighten cover screws to 15 ft-lb (20 N•m).
A conduit seal (D) is required within 18
in. (457 mm) of the motor for the US and
Canada.
Installation
torque.
torque.
11
Advertisement
Table of Contents
