Table of Contents
Advertisement
Revision 2.6
2.3.2 Option 2: Assign a temporary IP address to configuration computer
If the first option above is not used, you can use this option to communicate with WebRelay-
Quad™ . By default, WebRelay-Quad™ comes from the factory with an IP address of
192.168.1.2. Communications with WebRelay-Quad™ may be established by assigning an IP
address to the configuration computer that is on the same network as WebRelay-Quad™ (for
example the configuration computer could be assigned to 192.168.1.50) .
Instructions for changing the IP address of the computer that will be used for WebRelay-Quad™
configuration are given here. Note that these instructions are specifically for computers with the
Windows XP operating system. For setup using other operating systems, refer to the appropriate
users manual.
Step 1: Open the control panel by clicking on the start menu and then clicking on Control Panel.
(Note that control panel shown is in "Classic View". If control panel is in "Category View" select the
"Classic View" option before proceeding.)
Xytronix Research & Design, Inc.
WebRelay-Quad™ Users Manual
page 16
Advertisement
Table of Contents
Need help?
Do you have a question about the WebRelay-Quad X-WR-4R1-5 and is the answer not in the manual?