Rops (Roll Over Protective Structure) - HUSTLER SmoothTrak X-ONE Operator's Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 114
CZ
DA
DE
EN
ES
A. Bypass valve lever

ROPS (Roll Over Protective Structure)

A Roll Over Protective Structure (ROPS) and seat belt is
FR
provided with the equipment. Do not remove the ROPS and
seat belt.
A ROPS may minimize the chance of injury or death from
rollover.
A ROPS, when used with a seat belt, is effective in reducing
IT
injuries during unit overturn accidents. Overturning the unit
without a ROPS or without the ROPS locked in the raised
position (Figure 3-8) can result in serious injury or death.
Pivot the two-post ROPS down by removing the right and
left hair pins (Figure 3-8), and pulling out on the spring
NL
loaded pins to allow the machine to operate under low hang-
ing tree limbs or other obstructions.
NOTE: When the ROPS is locked in the raised position
make sure the hair pins are inserted into the holes in the end
of the spring loaded pins.
Do not wear the seat belt when the ROPS is in the lowered
PT
position. Use the ROPS in the "folded" position only when
absolutely necessary.
SV
REV B
A
Figure 3-7
A. ROPS
B. Hair pin
Do not operate the mower with the ROPS folded
down (lowered position) as a standard operating
mode. A folded down ROPS does not provide roll-
over protection.
Always wear your seat belt unless the mower is
not equipped with a ROPS or if the ROPS is folded
down. In this case, the seat belt should never be
worn.
To minimize chance of injury or death from rollover:
• Keep ROPS in the raised and locked position
and use the seat belt.
• Never operate the machine on a slope with the
ROPS folded down (lowered position).
• There is no roll over protection when the ROPS
is in the lowered position.
• Lower the ROPS only when absolutely neces-
sary. Drive slowly and carefully. Raise the
ROPS as soon as clearance permits. Read and
follow slope operation instructions and warn-
ings.
• Do not wear seat belt when the ROPS is in the
lowered position or if it is not equipped with
one.
3-4
A
B
C. Pin
Figure 3-8
606528CE
C

Advertisement

Table of Contents
loading

Table of Contents