HUSTLER FasTrak 36 Manual
Hide thumbs Also See for FasTrak 36:

Advertisement

This manual applies to the following Hustler equipment lines:
FasTrak 36/42
FasTrak 44/52
To the new owner
The purpose of this manual is to assist owners and operators in
maintaining and operating the FasTrak tractor and deck. Please read it
carefully; information and instructions furnished can help you achieve
years of dependable performance.
A separate Engine Owner's Manual is included with your owner's
packet which contains additional engine information that will not be
repeated in this manual. You are urged to read it before attempting any
operation or repair of the engine.
The Quick Reference Decals are designed to give the operator brief
information needed in the daily operation and service of the machine.
These decals are not intended to be used in place of this manual but instead
is to be used as an extension of this manual. These decals should not be
removed or obliterated. Replace these decals if they become unreadable.
It is the owner's responsibility to make certain that the operator reads
and understands this manual and all decals before operating this machine.
It is also the owner's responsibility to make certain that the operator is a
qualified and physically able individual, properly trained in the operation of
this equipment. Local regulations may restrict the age of the operator.
IMPORTANT: For more detailed maintenance and adjustment
information refer to the proper parts manual for your machine. Refer to
the Product Literature section of this manual for ordering information.
Using this manual
General operation, adjustment and maintenance guidance is outlined for
both the experienced and novice Hustler user. Operating conditions vary
considerably and cannot all be addressed individually. Through
experience, however, operators should find no difficulty in developing
good operating skills suitable to most conditions.
Directions used in this manual, for example RIGHT or LEFT, refer to
directions when seated on tractor facing forward, unless otherwise stated.
Photographs and illustrations used were current at the time of printing,
but subsequent production changes may cause your machine to vary
slightly in detail. Hustler Turf Equipment reserves the right to redesign and
change the machine as deemed necessary, without notification. If a change
has been made to your machine which is not reflected in this owner's
manual, or the parts manual, see your Hustler dealer for current information
and parts.
IMPORTANT: This engine is not equipped with a spark arrester muffler. It is a violation of California Public Resource Code Section 4442 to use or
operate this engine on any forest-covered, brush-covered, or grass-covered land. Other states or federal areas may have similar laws.
This spark ignition system complies with Canadian ICES-002.
The enclosed Engine Owner's Manual is supplied for information regarding the U.S. Enviromental Protection Agency (EPA) and the California
Emission Control Regulation of emission systems, maintenance and warranty.
Keep this Engine Owner's Manual with your unit. Should the Engine Owner's Manual become damaged or illegible, replace immediately.
Replacements may be ordered per the information found in the Product Information section of this manual.
600643 02/06

GENERAL INFORMATION

WARNING:
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
1
Warranty registration
The Delivery and Warranty Registration form must be completed and
signed to validate your warranty protection. As the new equipment owner,
you are expected to see that the form is completed and forwarded to Hustler
Turf Equipment at time of delivery.
Be sure to register the tractor plus each attachment that displays a model
and serial identification number plate with Hustler Turf Equipment.
IMPORTANT: Any unauthorized modification, alteration, or use of
non-approved attachments voids the warranty and releases Hustler Turf
Equipment from any liability arising from subsequent use of this
equipment.
Model and serial number
Tractor model and serial numbers are found on the serial identification
plate, located on the frame directly below and to the left of the operator's
platform.
These numbers are required on the Warranty Registration form. They
will also assure you of the correct service parts when replacement becomes
necessary.
Parts and service
Use original Hustler replacement parts only. These parts are available
through your local Hustler dealer. To obtain prompt, efficient service,
always provide the following information when ordering parts:
1. Correct part description
2. Correct model number.
3. Correct serial number.
All warranty repair and service must be handled through an authorized
Hustler dealer. Arrangements should be made through your local service
center.

Advertisement

Table of Contents
loading

Summary of Contents for HUSTLER FasTrak 36

  • Page 1: General Information

    FasTrak 36/42 signed to validate your warranty protection. As the new equipment owner, FasTrak 44/52 you are expected to see that the form is completed and forwarded to Hustler Turf Equipment at time of delivery. To the new owner Be sure to register the tractor plus each attachment that displays a model The purpose of this manual is to assist owners and operators in and serial identification number plate with Hustler Turf Equipment.
  • Page 2 FOUR YEAR FULL WARRANTY FOR RESIDENTIAL USE (ONE YEAR LIMITED WARRANTY FOR COMMERCIAL USE) c. Hustler Turf Equipment provides a limited warranty for the entire WHAT IS COVERED BY THIS WARRANTY length of ownership by the original purchaser (commercial or Hustler Turf Equipment, makes the following warranty to the original residential).
  • Page 3 This machine like any other powered equipment is potentially state. dangerous unless properly operated. Any operator must be cautious and keep safety in mind at all times. Any operator, prior to using the Hustler Turf Equipment, should thoroughly familiarize himself with the owner's LIMITATION OF REMEDIES...
  • Page 4 He must promptly notify Hustler Turf Equipment, or an WHO MUST PERFORM THE WARRANTY SERVICE ● All warranty service will be performed by dealers authorized by Hustler authorized dealer, in writing of the defect. In no event shall such Turf Equipment. Service calls and/or transportation expense of the...
  • Page 5 LIMITATION OF REMEDIES In no case shall Hustler Turf Equipment, be liable for any special, keep safety in mind at all times. Any operator, prior to using the Hustler incidental, or consequential damages based upon breach of warranty, Turf Equipment, should thoroughly familiarize himself with the owner's...
  • Page 6 600643 02/06...
  • Page 7: Safety Precautions

    SAFETY PRECAUTIONS The Quick Reference Decals are designed to give the operator brief information needed in the daily operation and service of the machine. These decals are not intended to be used in place of this manual but instead is to be used as an extension of this manual. These decals should not be removed or obliterated.
  • Page 8: Safety And Instruction Decals

    Safety and Instruction Decals ▲ ▲ Specific safety warning decals are located on the equipment near the immediate areas of potential hazards. These decals should not be removed or obliterated. Replace them if they become non-readable. The following illustrations show the various decals that are located on the machine. A brief explanation, for those requiring one, is shown to help the operator understand the meanings of these decals.
  • Page 9: Slope Guide

    SLOPE GUIDE Use this diagram when determining the degree of slope to be mowed. E (15 Slope Guide Lines D (10 C (5 Line A 1. Hold this sheet of paper in front of you. Make sure that line A is horizontal. 2.
  • Page 10 600643 02/06...
  • Page 11: Safe Operating Practices

    ▲ To comply with the thrown object safety requirements, Gator blades other types of hazards to avoid a wheel dropping over the edge or to are to be used on the FasTrak 36/42 or FasTrak 44/52 only when the avoid the ground from breaking away. This will help avoid machine correct mulch kit is installed.
  • Page 12: Control Panel

    Just remember to always exercise extreme injury. ▲ The Hustler mower is capable of operating horizontally (traverse) on caution when operating on any slope. moderately steep slopes. When operating on slopes up to 15...
  • Page 13: Safety Start Interlock System

    (is not opening or closing) and if the cause can not be determined, replace the seat switch. Deck lift If the problem can not be located, contact your Hustler Dealer. pedal WARNING: The safety interlock system should always function per steps 4 and 5.
  • Page 14: Driving The Tractor

    FasTrak 36/42 - Both bypass valve rods are located underneath the rear equipment before attempting normal speed operation. An of the tractor at the back of the integrated pump/motor transmissions. (Fig.
  • Page 15 FRONT OF TRACTOR FACES THIS DIRECTION FORWARD TRAVEL PIVOT TURN FORWARD TRAVEL REVERSE TRAVEL REVERSE TRAVEL RIGHT TURN RIGHT TURN N = Neutral Position Direction of arrows indicate direction of tractor movement. Figure 3-7 WARNING: The unit’s control levers are very responsive: Direct grass discharge to right, away from unmown area.
  • Page 16: Mower Deck Operation

    (in tall grass for example) can cause belts and/or electric clutch to slip, resulting in premature wear or possible damage. Step 1 Deck cutting height adjustment FasTrak 36/42 Deck height is adjustable from 1-1/2” - 4” (3.81 - 10.16 ) in 1/4”...
  • Page 17 Anti-scalp wheels Anti-scalp Anti-scalp wheel kits are standard on Hustler Mid Mount Z units. wheel These anti-scalp wheels are designed to minimize scalping when mowing on rough uneven terrain. After setting the cutting height, adjust the front anti-scalp wheels so they extend below the deck but do not contact the ground.
  • Page 18 600643 02/06...
  • Page 19: Torque Values

    ▲ Unless specifically required, DO NOT have engine running when caution when servicing them. servicing or making adjustments to tractor. Place control levers in ▲ Use only genuine Hustler replacement parts to ensure that original the park brake position, disengage deck clutch, remove ignition standards are maintained switch key and disconnect negative battery cable before doing any maintenance.
  • Page 20: Electrical System

    200 hours or 2 years whichever comes first. The required service involves Never attempt to start engine when there is a strong odor of draining the oil and installing a new filter kit (Hustler p/n 789511). Fill gasoline fumes present. Locate and correct cause.
  • Page 21: Mower Blade Maintenance

    NOTE: A blade holding tool (part number 381442) is available from Hustler Turf Equipment. It is designed Belts to prevent the blades from rotating when they are being removed or Inspect belts frequently for wear and serviceability.
  • Page 22: Seat Adjustment

    Comparison of Warped and Straight Blades Cap screw Figure 4-5 Cutting Edge Twisted Blade Edge (Replace) Operator’s Cutting Plane platform Cutting Edge Straight Blade Edge End view of blades, comparing twisted and straighten blades. FasTrak 36/42 shown Figure 4-7 Figure 4-6 600643 02/06...
  • Page 23 Check fuel level Prior to each use Blades - sharpen & securely fastened Prior to each use Discharge chute - securely in place & FasTrak 36/42 shown in lowest position Prior to each use Grease deck height pivots Grease gauge wheel bearings Figure 4-8 Change engine oil &...
  • Page 24 FasTrak 36/42 Maintenance Locator Chart 1. Engine Oil Fill & Dipstick 2. Fuel Filter 3a. Engine Air Cleaner (Honda) 3b. Engine Air Cleaner (Kohler) 4. Engine Oil Drain Plug 5. Battery 6. Fuel Tanks 7. Gauge Wheel Bearing Zerks (2) 8.
  • Page 25 FasTrak 44/52 Maintenance Locator Chart 1. Engine Oil Fill & Dipstick 2. Fuel Filter 3. Engine Air Cleaner 4. Engine Oil Drain Plug 5. Battery 6. Fuel Tanks 7. Gauge Wheel Bearing Zerks (2) 8. Engine Oil Filter 9. Deck Lift Pivot Zerks (4) 10.
  • Page 26 600643 02/06...
  • Page 27: Troubleshooting

    FasTrak 36/42 and FasTrak 44/52 TROUBLESHOOTING The majority of operating problems that occur with a system can be traced to improper adjustments or delayed service. A consistently applied preventative maintenance program, as outlined in the maintenance section of this manual, will prevent many problems. The following chart is designed to help you locate a problem by suggesting probable causes and the recommended solutions.
  • Page 28 600643 02/06...
  • Page 29: New Season Preparation

    1. Remove all grass, dirt, and trash from tractor and mower. Clean engine flooding and loss of power. tractor and mower and touch up all scrapes with Hustler spray paint. 5. Remove and replace fuel filter if not done in previous 100 hours.
  • Page 30 600643 02/06...
  • Page 31: Table Of Contents

    Safety and instruction decals............8 Engine oil and filter..............21 Safety start interlock system ............13 Engine starting ................13 Seat adjustment ................22 FasTrak 36/42 and FasTrak 44/52 troubleshooting .....27 Slope guide..................9 FasTrak 36/42 maintenance locator chart ........24 FasTrak 44/52 maintenance locator chart ........25 Stopping the engine..............14 Storage..................29...
  • Page 32 600643 02/06...

This manual is also suitable for:

Fastrak 52Fastrak 42Fastrak 44

Table of Contents