HUSTLER SmoothTrak X-ONE Operator's Manual page 152

CZ
Verify safety start interlock system
DA Visually inspect unit for loose hardware and/or damaged parts
Visually inspect tires
Check oil level, engine (1)(4)
Clean air intake screen (8)
Check fuel level
Blades - sharpen & securely fastened
DE
Discharge chute - securely in place & in lowest position
Rear discharge deck flaps and/or power unit deflector securely in place
Clean engine and pump compartment (11)
Check air cleaner service indicator (8)
Replace engine air cleaner element (5)(10)
EN
Change engine oil and filter (1) (4)
Clean cylinder and head fins (10)
Check battery connections (11)
Check tire pressure with a gauge
Check hydraulic oil level (11)
ES
Clean engine exterior (10)
Tighten lug nuts on wheels (2)
Grease deck pusher arms (8)
Grease pump idler (8)
Grease deck height pivots (8)
FR
Grease front wheel bearings (8)
Clean & regap spark plugs (10)
Check pump and deck belt tension and condition (6) (11)
Check fuel system (7) (11)
Check fuel valve (7)
IT
Check fuel tank grommets (7)
Change fuel filter (7)
Change hydraulic filter & oil (3) (11)
Grease deck spindle housings
Replace spark plugs (10)
NL
Check ROPS mounting hardware (9)
Replace fuel evaporation system filter (8) (11)
NOTES:
Initial engine oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or
1.
dirty conditions and during hot weather periods.
Torque initially and after first 2 hours of operation.
2.
PT
Perform initial hydraulic oil and filter change after 50 hours (one week) of operation. Thereafter, change oil and filter annually or every 500 hours
3.
(750 hours for Parker HT-1000 oil) whichever comes first.
Change engine oil filter per the engine manufacturer's recommendations. Refer to Engine Owner's Manual for recommendations and other
4.
maintenance items.
Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter
5.
element. Replace with a new one.
Pump drive belt only - Inspect belt every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise,
6.
replace belt every 400 hours or 2 years whichever comes first. Check and adjust spring tension after 50 hours of use as outlined in the Hydraulic
SV
Pump Belt Adjustment section of the General Service Manual (123499).
Check fuel system for any cracks or leaks including, but not limited to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon
7.
canister, and grommets. Replace as needed.
REV B
Maintenance Schedule
Refer to Figure 4-18, Figure 4-19, Figure 4-20, & Figure 4-21
SERVICE AT
INTERVALS INDICATED
WEEKLY
OR 50
HOURS
Prior to each use or every 4 hours
Prior to each use or every 4 hours
X
X
X
X
X
X
X
4-10
MONTHLY * ANNUALLY
OR 100 OR 500
HOURS HOURS
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Daily
Daily
As needed
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
606528CE