Important Warnings - B+S UFWWD Series Installation, Operating And Servicing Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

TABLE 5: Plumbing Connections

Water Inlet (W)

Gas Inlet (G)

Water Outlet/Waste (D)

REGULAR INSPECTIONS BY AN AUTHORISED SERVICE PERSON ARE STRONGLY RECOMMENDED TO

ENSURE PROPER AND SAFE FUNCTIONING OF THIS APPLIANCE.

AFTER ANY SERVICING OR ADJUSTING OF GAS CONNECTED COMPONENTRY, GAS LEAK TEST MUST BE

CARRIED OUT TO ENSURE THERE ARE NO GAS LEAKING HAZARDS.

NEVER STORE ANY FLAMEABLE LIQUIDS/VAPOURS IN VICINITY OF THIS APPLIANCE. NEVER SPRAY

AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.

ENSURE ANY TRANSIENT PROTECTION IS REMOVED BEFORE INSTALLING THE APPLIANCE ENSURING

ANY POSSIBLE DAMAGE TO THE APPLIANCE OR COMPONENTS/ PARTS THAT MAY HAVE BEEN

SUSTAINED DURING TRANSPORTATION IS REPORTED TO THE MANUFACTURER.

THIS APPLIANCE IS NOT INTENDED TO BE USED IN A MARINE ENVIRONMENT. ENSURE APPLIANCE IS

INSTALLED IN A STABLE POSITION.

FAILURE TO FOLLOW THE INFORMATION PROVIDED IN THIS BOOKLET WILL VOID THE B&S WARRANTY

AND MAY RESULT IN DAMAGE TO EQUIPMENT OR INJURY TO PERSONNEL.

Please note that checking and adjusting of burner pressures on commercial catering appliances is an obligation of

gasfitters.

The relevant legislation is as follows from the Plumbing Regulations 2008 administered by the Victorian Building

Authority:

Gas fitting work defined

(1) Gas fitting work is the construction, installation, replacement, repair, alteration, maintenance, testing or

commissioning of any pipe, appliance, flue, fitting, apparatus, control or other item that is involved with the

supply or use of gas and that is fitted downstream of the outlet of a customer billing meter or a consumer's

gas storage container

As per AS/NZS5601.1, clause 6.11.1, this gas appliance must be commissioned by a suitably authorized person

who;

Connection

Position from

Floor

(mm)

½" Copper

600(+/-5)

¾" male BSP

500(+/-5)

2" BSP

620 (+/-5)