Table of Contents
Advertisement
FAILURE TO DO SO WILL VOID B&S WARRANTY AND MAY RESULT IN DAMAGE TO EQUIPMENT OR INJURY
Please note that checking and adjusting of burner pressures on commercial catering appliances is an obligation of
gasfitters.
The relevant legislation is as follows from the Plumbing Regulations 2008 administered by the Victorian Building
Authority:
Gas fitting work defined
(1) Gas fitting work is the construction, installation, replacement, repair, alteration, maintenance, testing or
commissioning of any pipe, appliance, flue, fitting, apparatus, control or other item that is involved with the
supply or use of gas and that is fitted downstream of the outlet of a customer billing meter or a consumer's gas
storage container
As per AS/NZS5601.1, clause 6.11.1, this gas appliance must be commissioned by a suitably authorized person who;
(a) Installed the appliance when gas is available at the time of installation; or
(b) Makes gas available to the appliance if gas was not available at the time of installation
As per AS/NZS5601.1, clause 6.11.3, the commissioning of this appliance shall take full account of special design
features, the manufacturer's instructions and the appliance safety requirements.
As per AS/NZS5601.1, clause 6.11.4, the commission of this appliance shall include all of the following;
(a) Testing and purging of the appliance and installation as appropriate.
(b) Checks to ensure the appliance is in safe working order.
(c) Ignition of each burner of the appliance and where necessary adjustment, in accordance with the
manufacturer's instructions.
(d) Testing of flue performance.
(e) Testing of all safety devices for correct operation.
(f) Instruction of the consumer, where available, on the safe and correct operation of the appliance and any
auxiliary equipment.
(g) Handing of the appliance operating instructions to the consumer, or if the consumer is not present, leaving
the instructions in a suitable location on the premises.
Installation Instructions
Regulations
This appliance shall be installed only by authorized persons and in accordance with the manufacturer's installation
instructions, local gas fitting regulations, municipal building codes, AS 5601 – Gas Installations and any other statutory
regulations.
IMPORTANT WARNINGS
ENSURE ANY
TRANSIT
INSTALLING THE APPLIANCE.
THIS APPLIANCE IS NOT INTENDED TO BE INSTALLED OR USED IN A MARINE
ENVIRONMENT. ENSURE APPLIANCE IS INSTALLED IN A STABLE POSITION.
INSTALATION AND SERVICING SHALL BE CARRIED OUT ONLY BY
AUTHORISED PERSONNEL.
TO PERSONNEL.
PROTECTION
IS
6
REMOVED
BEFORE
Advertisement
Table of Contents
