Advertisement
Available languages
Available languages
Flushing Volume
If you need to regulate the flushing volume, you can
take off the cover and turn the adjusting screw in the
center of the stop valve to a proper place.
Manual Flushing
Approach the supplied special magnetic stick
(flushing control stick) to the middle part of the
sensor lens. The system is now at manual status
and the indicator will flash every 1 seconds.
Approach the flushing control stick to the window, it'll
start to flush; approach again, stopping flushing.
This status will last for 8 minutes until it turns to
the normal working status. (The flushing, if any,
will be terminated when this status ends).
NOTICE: The longest flushing time is 30 seconds
once. If the flushing control stick keeps near to the
s e n s i n g w i n d o w , t h e m a n u a l s t a t u s w i l l b e
terminated automatically and reassume the normal
working status.
MAINTENANCE
Urinal Repair :
When repairing, you don't have to dismount the sensor. Cover the sensing window with tape and work with ease.
CAUTION : Don't use very adhesive tape in case the scar will be hard to remove.
Care & Cleaning
Keep the sensor window clean. wipe the soft cloth and mild cleaner.
CAUTION :
a. Do not use dust-removing powder, abrasive powder or cleaner containing oil, acid or alkaline ingredient.
b. Do not spray air-refresher, disinfect, or other deodorizing, cleaning solvent directly into the sensor.
c. Keep wire away from water.
d. Don't attack the sensor window.
Clean the Filter Screen
If the flushing volume reclines sharply after installation or used for a long time with no cause from water pressure,
the filter may need a wash.
Turn off the fixed cap with filter-key, take out the filter, clean with a brush and reinstall it.
Notice: T urn off the water supply or tighten the adjusting bolt before cleaning.
Kohler Co.
Filter
Fixed Cap
Filter-Key
7
Adjusting Screw
Hex Wrench
Flushing control stick
1106445-X2-A
Advertisement
