Maintenance - Kohler Bardon K-8787T-C01 Installation Instructions Manual

Flushing Volume
Water pressure 0.3MPa: The automatic flushing volume is 2
to 4 liters. Adjust when smaller volume is required.
Remove the sensor cover when adjusting. Turn the adjusting
bolt to a proper place.
0.3MPa

MAINTENANCE

Urinal Repair
When repairing, you don t have to dismount the sensor.
Cover the sensing window with tape and work with ease.
¢
Notice : Don t use very adhesive tape in case the scar
will be hard to remove.
Clean the Filter Screen
If the flushing volume reclines sharply after installation or
used for a long time with no cause from water pressure, the
filter may need a wash.
Turn off the fixed cap with filter-key, take out the filter, clean
with a brush and reinstall it.
Notice: Turn off the water supply or tighten the
adjusting bolt before cleaning.
Care & Clean
Keep the sensing window clean. Wipe with soft cloth and mild
cleaner.
Notice:
a. Do not use dust-removing powder, abrasive powder
or cleaner containing oil, acid or alkaline ingredient.
b. Do not spray air-refresher, disinfector, or other
deodorizing, cleaning solvent directly into the
sensing window.
c. Keep wire away from water.
¢
d. Don t attack the sensor window.
1020018-T01-C
2-4L
¢
Adjusting Bolt
1021430
Filter-key
a.
b.
c.
d.
-9-
Filter
Fixed Cap