Table of Contents
Advertisement
ID when creating VLAN, ranging from 2 to 4094. The switch creates VLAN1 by default and
VLAN1 cannot be deleted.
Application Example
Networking Requirement
There are two users, user 1 and user 2. These two users need to be in different VLAN due to
different network function and environment. User 1 belongs to VLAN2, connecting to switch
port G1/1 (Gigabit Ethernet 1/1); user 2 belongs to VLAN 3, connecting to switch port G1/2
(Gigabit Ethernet 1/2).
Configuration Steps
The switch configuration is shown as follows.
1. Log in to the device. Refer to "4.1 First Login by Console Port".
2. Run the following command to create VLAN.
SWITCH #configure terminal
SWITCH (config)#vlan 2
SWITCH (config-vlan)# exit
SWITCH (config)#vlan 3
SWITCH (config-vlan)# exit
3. Run the following command to distribute ports into the VLAN.
SWITCH (config)# interface GigabitEthernet 1/1
SWITCH (config-if)# switchport access vlan 2
SWITCH (config-if)# exit
SWITCH (config)# interface GigabitEthernet 1/2
SWITCH (config-if)# switchport access vlan 3
SWITCH (config-if)# exit
Figure 4-2 VLAN networking
11
Advertisement
Table of Contents
