EN
10
Assembly
5. ASSEMBLY
For the purpose of transportation, the lawnmower is supplied disassembled. Before use, it must be assembled
according to the following steps:
5.1 INSTALLATION OF THE START UNIT TO THE TOP PART OF THE HANDLE
Fig. 2.1
Place the start unit against the handle, see figure 2. 1
Put on the bottom fastening part, see figure 2.2
Join both parts together using the included screws and tighten appropriately. Figure 2.3
5.2 INSTALLING THE HANDLE
Fig. 3.1
Prior to installing the handle, slide the power cord holding hook on to the top part. Figure 3. 1
Connect the top and bottom part of the handle using the included screws and nuts with quick coupler levers.
Figure 3.2
Connect the bottom part of the handle to the lawnmower. Figure 3.3
Attach the power cord to the handle using the plastic clips.
Note: The handle is height-adjustable and can be folded down for storage.
Fig. 2.2
Fig. 3.2
Fig. 2.3
Fig. 3.3
FZR 2025-E