User Information - SPECTRO SPECTROLAB Original Operating Instructions

Safety
2.2

User information

Caution! Risk of injury and health hazard!

Non-compliance with the operating and safety instructions may lead to injuries
and can cause a health hazard.

Carefully read the manual and always comply with the safety instructions.

The instrument - in its transport packaging - may only be transported by
expert organizations or by specifically trained personnel.

If an instrument is positioned on a sloped surface and equipped with wheels, it
may roll away during the operation. Secure the instrument while in operation.
This applies also when the instrument is being transported.

Unpacking, installation, setup and connection of the instrument may only be
performed by service personnel that is authorized by the manufacturer.

The instrument may only be connected to the mains power supply with a
protective grounding conductor.

The instrument may be operated only in a dry environment (protection class
IP 22, DIN 40050).

Prior to opening the instrument, disconnect the power. The instrument is only
completely disconnected from power if the power plug is removed.

Never tamper with the safety devices! If it is suspected that a safety device
does not work properly, shut down the instrument immediately. Please contact
your Service Center.

Compliance with the information labels on the instrument is mandatory.

While operating and maintaining the instrument, compliance with all safety
and accident prevention regulations is mandatory. This is specified in DIN EN
61010 or a comparable national standard.

Compliance with the relevant safety regulations when using tools and
operating equipment is mandatory.

Carry out only the maintenance work that is described in chapter "" of the
instruction manual. The operating personnel is not permitted to proceed with
any other maintenance work. Any further services (e.g. technical
maintenance) or repairs must only be performed by service personnel that are
authorized by the manufacturer.

The safety measures must be checked following every technical maintenance
or repair activity. This check must be performed according to VBG4/DIN EN
61010 or a comparable national standard.

Compliance with the maintenance schedule specified by the manufacturer is
mandatory, All maintenance activities must be recorded. This will maintain the
operational safety of the instrument.

Only genuine spare parts must be used when repairing the instrument. The
use of non-genuine spare parts will make the CE Declaration of Conformity
null and void.
— 10
SPECTROLAB — 30.07.2015