Creating A Report; Pre-Repair Scan - Zenith Z5 User Manual

11.2 Creating a report

A new report is created in the following sequence:

Pre-repair Scan

•System Search
•DTC Analysis
•Save Pre-scan Result
⚫ Pre-repair Scan
In order to create a diagnostic report, you must start from selecting [DIAGNOSIS] from
Z5 main menu to perform [System Search] on the vehicle.
Please refer to [5.2 System Search & 5.3 DTC Analysis] of [Chapter 5. Diagnosis -
General] in this manual for more details.
[System Search] scans all available control systems equipped in the vehicle and
displays the number of DTCs logged in each control system.
After [System Search] or [DTC Analysis] is completed, selecting [Show DTC] will show
the detailed list of detected system and DTCs, and activate the [REPORT] button at the
top of right.
Once [REPORT] button is selected, previously saved reports are displayed if available.
Repair
Service
User Manual ver.1.03
Post-repair Scan
•System Search
•Save Post-scan Result
127