Dürkopp Adler 52 i Series Operating Instructions Manual page 54

52
Setting the zig-zag stitch position
1. Press the arresting lever (3) in the arrow direction until it
strikes the lever (2).
 The arrest of lever (2) and lever (1) is released.
Important
Make sure that the lever (2) setting does not change at the arrest
switching off.
1. Press the lever (1) and turn it at the same time up to the stop
(inside the machine) against the respective symbol indicating
the zig-zag stitch position. Only the middle position of the lever
is arrested with a lock.
2. After the lever (1) setting, carry out arresting with the lever (3).
Information
In picture there are examples of setting the zig-zag stitch width
and position from which it is visible that the zig-zag stitch width
does not change at the position change.
Operating Instructions 52Xi, 52Xi-75 - 00.0 - 10/2021
Operation