Mercedes-Benz Mercedec-AMG GT R Owner's Manual page 131

128 Driving and parking
The vehicle as well as persons and objects
R
are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 2,
#
or 4 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles
#
from a distance of 1 cm to 8 cm front of the
inside rearview mirror. You should test every
position for at least 25 seconds before trying
another position.
Hold remote control
#
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
On remote controls that transmit only for a
#
limited period, press button
control 5 again before transmission ends.
3
Align the aerial line of the door opener unit
#
with the remote control.
% Support and additional information on pro‐
gramming:
on the HomeLink
R
(0) 08000 466 354 65 or
+49 (0) 6838 907 277
on the Internet at https://
R
www.homelink.com
Opening or closing the garage door
Requirements:
The corresponding button is programmed to
R
operate the door.
5 at the same angles
#
#
6 on remote
Clearing the garage door opener memory
#
#
®
Hotline on
Press and hold buttons 2, 3
the door opens or closes.
If indicator lamp 1 flashes yellow after
approximately 20 seconds: press and hold
the previously pressed button again until the
door opens or closes.
Press and hold buttons 2 and 4.
Indicator lamp 1 lights up yellow.
If indicator lamp 1 flashes green: release
buttons 2 and 4.
The entire memory has been deleted.
or 4 until