Mercedes-Benz Mercedec-AMG GT R Owner's Manual page 123

120 Driving and parking
This also applies to the Digital Vehicle Key if the
"Digital Vehicle Key" function is activated via
Mercedes me connect.
Use the E-SELECT selector lever to change the
transmission position. The current transmission
position is displayed in the multifunction display.
j Park position
k Reverse gear
i Neutral
h Drive position
Engaging reverse gear R
Depress the brake pedal and push the E-
#
SELECT selector lever upwards past the first
point of resistance.
Engaging neutral N
Depress the brake pedal and push the E-
#
SELECT selector lever up or down to the first
point of resistance.
Subsequently releasing the brake pedal will
allow you to move the vehicle freely, e.g. to push
it or tow it away.
If you want the automatic transmission to
remain in neutral i i even if the ignition is
switched off:
start the vehicle.
#
depress the brake pedal and engage neutral
#
i.
release the brake pedal.
#
switch the ignition off.
#
%
If you then exit the vehicle leaving the key in
the vehicle, the automatic transmission
remains in neutral i.
Engaging park position P
Observe the notes on parking the vehicle
#
( page 125).
/
Depress the brake pedal until the vehicle is
#
stationary.
When the vehicle is stationary, press button
#
j.
Park position is only engaged when the
transmission position display j is shown in
the multifunction display. If no transmission
position display j appears, secure the vehi‐
cle to prevent it from rolling away.
Park position j is engaged automatically if one
of the following conditions is met:
you switch off the ignition when the vehicle
R
is stationary and the transmission is in posi‐
tion h or k.
you open the driver's door when the vehicle
R
is stationary or when driving at a very low
speed and the transmission is in position h
or k.