Before Use - Kayoba 008015 Operating Instructions Manual

USE
ROZKŁADANIE
Pull up the lock sleeve on the front from the
back slots and unfold the front part from the
back part. When the lock sleeve clicks in place
in the front slots the unfolding is complete.
FIG. 4
SKŁADANIE
1. Pull up the lock sleeve on the front from
the front slots and fold the front part in to
the back part.
2. When the lock sleeve clicks in place in the
back slots the folding is complete.
FIG. 5
ADJUSTING THE STEM HEIGHT
Open the lock on the stem
1. Open the lock on the stem (5).
FIG. 6
2. Press in the spring loaded ratchet (visible
in one of the three height adjustment
holes) and pull out the stem to the
position that suits the length of the rider
best. The ratchet automatically locks the
stem when it springs out in the height
adjustment hole.
1. Ratchet
FIG. 7
3. Close the lock on the stem (5).
FIG. 8
WARNING!
• The stem is in its highest position when
the ratchet is in the top height
adjustment hole. Do not attempt to set
the stem to a higher position than this.
• The ratchet must be perfectly centred
and engaged in one of the height
adjustment holes.
HOW TO USE
WARNING!
Always wear a helmet and personal safety
equipment.

Before use

Close the lock and check that the lock sleeve
on the front has properly engaged in the front
slots – otherwise the product can collapse and
cause the rider to fall off and suffer personal
injury.
Driving
1. Switch on the power by pressing the
power switch for three seconds. Read off
the charge for the battery.
1. Switch
FIG. 9
2. The safest way of starting is to stand with
one foot on the foot plate (9) and allow
the other foot to trail on the ground in
support for the first few seconds after
starting. Lift the foot from the ground,
put it on the foot plate (9) and gently
increase power to the motor when the
speed is about 10 km/h. This technique is
safer than trying to balance with both feet
on the foot plate (9) from the beginning.
Adjust the speed to the conditions by
gently and carefully operating the motor
control (2).
FIG. 10
3. To stop, release the motor control (2),
brake carefully with the hand brake and
step off the foot plate (9) one foot at a
time. Take special care when using the
product the first few times.
FIG. 11
4. Switch off the power after use.
1. Switch
FIG. 12
EN
41