Transferring To Computer - OKM ROVER C4 Manual

5.1.1.2 Transferring to Computer

If you selected "Computer" as transfer mode, you need to establish a wireless data con-
nection to the Visualizer 3D Studio software on your PC.
7
Rover C4 is now waiting for an incoming Blue-
tooth connection from your computer with Vi-
sualizer 3D Studio.
8
Set up your Visualizer 3D Studio software with
all the corresponding settings as explained in
chapter „6 PREPARING DATA TRANSFER" on
page 34.
9
After the Bluetooth connection is established
you can start your first scan line by pushing
the button.
Read section „5.1.2 Conducting a 3D Ground
Scan" on page 20
to learn more about con-
ducting a complete ground scan.
If you are going to cancel this operating mode
simply push the button.
19 / 36
10
After canceling the 3D Ground Scan screen,
the device also exits the wireless data con-
nection before returning back to the main
menu.