Solar Blue Table Top - LABORIE Solar Blue Service & Installation Manual

2.3

Solar Blue Table Top

The Solar Blue wireless table top setup is the smallest and the most cost
effective set-up, when minimum of office space is required.
Figure 2.1 Wireless table-top setup
In this setup, the Solar Blue module and the other devices can be put on a
table. A clamp on the Solar Blue module is not necessary. Please note that the
Solar Blue module will be top-heavy.
The installation procedure is as follows:
 Install the LABORIE software (see the software installation manual
(document code 0075-MAN-092-EN)).
 Assemble and install the Solar Blue module (see chapter 4).
 If applicable, install the safety module (see § 2.7).
 Install the devices as supplied with your system: remote control (chapter 5),
Bluetooth flowmeter (chapter 6), Bluetooth puller (chapter 7), or Luna
module (chapter 8).
Solid state catheters and air-charged transducers/catheters can be connected
to the Solar Blue module easily. Please consider that in case pressure
measurement is performed with water catheters, the transducer holder must
be mounted to a pole or mounted otherwise. Different clamps are available
(see § 2.8).
22
© 2008 – 2020 by MMS B.V.
Chapter 2