Terminating Expansion Microphone Upgrade - Avaya B199 Manual

Features and accessories
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: 86%
When the upgrade is complete for both microphones, their LEDs turn off, and Avaya Conference
Phone B199 displays the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: Done
In 10 seconds, the pop-up dialog window hides, and the phone enters Idle mode.
If the firmware upgrade for any of the expansion microphones fails, the microphone LEDs turn off,
and the phone displays the message stating the Failed status of the corresponding Smart Mic.

Terminating expansion microphone upgrade

About this task
Use this procedure to terminate the expansion microphone upgrade.
You can do it in the following cases:
• The phone has one Smart Mic 1 connected; or
• The phone has both Smart Mic 1 and Smart Mic 2 connected simultaneously.
Before you begin
Connect Smart Mic 1 and Smart Mic 2 to the phone and start the upgrade process for both
expansion microphones.
Procedure
1. Detach Smart Mic 2 from the phone.
Smart Mic 1 continues upgrading with the value for the upgrade progress being updated.
Smart Mic 2 upgrade dialog indicates an error and aborts the mic upgrade. Avaya
Conference Phone B199 displays the following message:
Upgrade in progress
Smart Mic 1: 50%
Smart Mic 2: Failed
When Smart Mic 1 upgrade is complete, its LED turns off, and Avaya Conference Phone
B199 displays the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: Failed
This message disappears in 10 seconds.
2. (Optional) To upgrade Smart Mic 2, connect it to the conference phone and proceed with
the upgrade.
September 2021 Using Avaya Conference Phone B199
Comments on this document? infodev@avaya.com
56