Upgrading Two Expansion Microphones - Avaya B199 Manual

When you connect one Smart Mic to B199, the phone shows the upgrade status for Smart
Mic 2 as N/A.
Smart Mic 1: 10%
Smart Mic 2: N/A
3. (Optional) To cancel the upgrade, tap No.
In this case, you postpone the upgrade until the phone reboots.
Result
If the upgrade is complete, the microphone LEDs turn off, and Avaya Conference Phone B199
displays the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: N/A
In 10 seconds, the pop-up dialog window hides, and the phone enters Idle mode.
If the Smart Mic firmware upgrade fails, the microphone LEDs turn off, and the phone displays the
Smart Mic 1: Failed message.

Upgrading two expansion microphones

About this task
Use this procedure to upgrade two expansion microphones connected to your device
simultaneously.
Before you begin
Connect Smart Mic 1 to the first audio expansion port of your conference phone.
Procedure
1. Connect Smart Mic 2 to your conference phone using the second audio expansion port.
The LEDs on the phone turn red to indicate that it is busy with the microphone upgrade.
The Smart Mic 2 LEDs start flashing green.
A pop-up dialog window provides the expansion microphones upgrade status in the
following format:
Smart Mic 1: 20%
Smart Mic 2: 10%
2. (Optional) Terminate Smart Mic 2 upgrade by detaching the expansion microphone from
the phone.
In this case, you postpone the upgrade until you connect Smart Mic 2 again.
Result
When the upgrade is complete for Smart Mic 1 and Smart Mic 2 is still upgrading, the LED turns
off on Smart Mic 1, and Avaya Conference Phone B199 displays the following message:
September 2021 Using Avaya Conference Phone B199
Comments on this document? infodev@avaya.com
Expansion microphone firmware upgrade
55