Checking The Tire Condition - Husqvarna TE 250i 2021 Owner's Manual

14.5

Checking the tire condition

Info
Only mount tires approved and/or recommended by Husqvarna Motorcycles.
Other tires could have a negative effect on handling characteristics.
The type, condition, and pressure of the tires all have a major impact on the handling characteristic of
the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
–
Position chain adjuster
it yet.
–
Make sure that chain adjusters
adjusting screws
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spin-
dle
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
H03708-11
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the front and rear tires for cuts, run-in objects, and
other damage.
» If the tires have cuts, run-in objects, or other damage:
–
Change the tires.
–
Check the tread depth.
Info
Adhere to the legally required minimum tread depth.
400602-10
Minimum tread depth
» If the tread depth is less than the minimum tread depth:
–
Change the tires.
WHEELS, TIRES 14
3 4
. Mount nut , but do not tighten
3
are fitted correctly on
5
.
p. 78)
.
M20x1.5 80 Nm (59 lbf ft)
3
can be turned by 180°.
≥ 2 mm (≥ 0.08 in)
p. 56)
103