Yamaha MT-07 Owner's Manual page 37

TIP
When removing the screwdriver, slide
the screwdriver toward the " " mark
on the passenger seat.
1
2
1. Screwdriver
2. " " mark
3. " " mark
3. Pass the helmet holding cable
through the buckle on the helmet
strap.
4. Hook the cable loops over the
screwdriver, install the screw-
driver by first inserting the screw-
driver into the holder with the " "
mark, and then slide the screw-
driver toward the holder with
the " " mark.
TIP
Make sure that the screwdriver is se-
curely positioned between its holders,
and then position the cable loops to-
ward the middle of the screwdriver be-
fore installing the passenger seat.
3
1
2
1. Helmet
2. Helmet holding cable
3. Screwdriver
4. Holder
5. Install the passenger
WARNING! Never ride with a
helmet attached to the helmet
holder, since the helmet may hit
objects, causing loss of control
and possibly an accident.
4-20
Instrument and control functions
To release a helmet from the helmet
holding cable
1. Remove the passenger seat.
2. Remove the screwdriver, then re-
move the helmet holding cable
from the helmet.
3. Store the cable under the seat by
hooking the cable loops over the
3
screwdriver, install the screw-
driver in its original position, and
then hook the helmet holding ca-
4 4 4
ble over the hook on the bottom of
the passenger seat.
1 1 1
seat.
1. Screwdriver
2. Helmet holding cable
3. Hook
4. Install the passenger seat.
[EWA10162]
4
2 2
3 3