Raider RD-TC01 User Manual page 10

10 www.raider.bg
handle machines, tools, or equipment.
4. STORE IDLE EQUIPMENT. When not in use, tools must be locked up in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. DO NOT FORCE THE TOOL. It will do the job better and more safely at the rate for which it was
intended. Do not use inappropriate attachments in an attempt to exceed the tool's capacities.
6. USE THE RIGHT TOOL FOR THE JOB. Do not use a tool for a purpose for which it was not
intended.
7. Dress Properlyerly. Do not wear loose clothing or jewelry, as they can be caught in moving
parts. Non-skid footwear is recommended. Wear restrictive hair covering to contain long hair.
Always wear appropriate work clothing.
8. USE EYE, EAR and breathing PROTECTION. Always wear approved impact safety goggles
if you are producing metal filings or wood chips. Wear an approved dust mask or respirator when
working around metal, wood, and chemical dusts and mists. Use approved ear protection when
working in a loud or noisy environment.
9. DO NOT OVERREACH. Keep proper footing and balance at all times. Do not reach over or
across running machines.
10. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Control handles must be kept clean,
dry, and free from oil and grease at all times.
11. STAY ALERT. Watch what you are doing. Do not operate any machinery when you are tired.
12. Do Not operateerate machinery while under the influence of alcohol, Drugs, or prescription
medicines.
13. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its intended
function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures,
and any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician.
14. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts, available from Harbor Freight Tools. Use of any other parts will void the warranty.
Using this Tool may create special hazards.
Take particular care to safeguard yourself and those around you.
Do not exceed the material thickness limitation. You can make straight cuts in tiles up to 5/8" thick,
and cut holes in tiles up to 3/8" thick with this machine. Attempting to cut thicker material may cause
damage to the machine and potential personal injury.
Crushing and Marring. Using excessive force on the lever, or using dull or dirty cutter wheels can
cause damage to your workpiece. Before cutting any material with this tool, assure that the cutting
wheel or tip is in good condition. When moving the handle, assure that the pressure applied is
appropriate to the thickness and hardness of the tile being scored.
Guiding and Supporting Materials. Materials must be supported while scoring, or breaking.
Wear Eye protective glasses when operating this tool. Occasionally splinters or shards may split
off and be ejected whil using this tool. Protect your eyes to prevent injury.
Avoid injury to your hands and fingers. Keep your hands away from the moving and cutting parts
of this tool during operation.
NOTICE: No list of warnings can be all inclusive. The operator must
supply common sense, and operate this tool in a safe manner.
Assembly
Your Tile Cutter is mostly assembled when you receive it. Please complete the assembly as
follows.
Install the Bottom Feet.
SPECIAL WARNINGS WHEN USING THIS TILE CUTTER