Euro-Pro Shark Retractor Transformer Vac Owner's Manual page 7

DIRECTIVES D'UTILISATION
Avertissement:
Toujours débrancher
l'aspirateur avant l'assemblage ou
l'enlèvement d'accessoires.
Extension du Tube Télescopique
Enfoncez le bouton de verrouillage et
tirez vers le haut sur le plus gros tube.
(Fig. 1)
Fig. 1
Bouton de
verrouillage
Insertion du Tube Télescopique
dans le Boîtier
• Insérez le tube télescopique dans le
trou adjacent à la poignée de la
coupelle de récupération. Assurez-
vous que la fente de la poignée
s'insère bien dans l'orifice. (Fig. 2)
• Pour enlever le tube télescopique,
appuyez sur le bouton de relâche du
tube télescopique et tirez le tube vers
le haut.
Fig. 2
Fixation de la Brosse à Planchers
au Boîtier
• Insérez le brosse au bon endroit,
dans le sens de la flèche. (Fig. 3)
• Pour retirer la brosse du boîtier
principal, appuyez sur le bouton de
relâche de la brosse et tirez la brosse
du boîtier.
Bouton de
Relâche
de la brosse
à planchers
Fixation de la Brosse à Planchers
au Boîtier
• Tenez le bout du boyau.
• Insérez le boyau dans son raccord.
(Fig.4)
Fig. 4
24
Winding & Unwinding the Power
Cord
Your vacuum cleaner includes
a power cord which is
automatically retractable.
To extend your power cord,
pull from side and extend
to desired length up to
the yellow mark on the
power cord. (Fig. 5)
Do not pull the power
cord beyond the red
mark. When vacuuming
is finished, first switch
off power and disconnect plug from
electrical outlet. Then press on cord
rewind button. If the cord does not fully
retract, pull it out again and then press
on cord rewind button.
Warning:
Hold the plug when
rewinding the cord. Do not allow the
cord to whip when rewinding.
On/Off Switch
Fig. 3
• The On/Off switch has two different
positions.
• Push on the "I" side to turn the
vacuum ON.
• Push on the "O" side to turn the
vacuum OFF.
= OFF
= ON
Using the Unit as an Upright
• Unwind the power cord and plug into
the 120V outlet.
• Push down on the
locking button to adjust
the height of the
telescopic handle.
Note:
When vacuuming
deep pile carpets or hard
to vacuum carpets,
lower the angle of
the telescopic
handle (see
illustration at
right) for easier maneuverability.
OPERATING INSTRUCTIONS
Using the Unit as a Hand Vacuum
• Press the telescopic tube release
button to remove the telescopic tube.
(Fig. 2)
• Press the floor brush release button to
remove the floor brush. (Fig. 3)
• Attach the shoulder strap to the
shoulder strap attachment point.
(Fig. 6)
• Attach the crevice tool or the dusting
Yellow
brush to the end of the hose.
Red
Fig. 5
Warning:
After extended use, the body
of the vacuum cleaner may become hot.
When using the unit with the shoulder
strap, the unit will touch the body of the
user. Therefore, make sure that the unit
body is cool before you use with the
shoulder strap. If during use, the vacuum
gets too warm, allow it to cool before
continuing to use.
Crevice Tool
For radiators, crevices, corners,
baseboards and
between cushions.
Dusting Brush
The dusting brush is
used for the furniture,
venetian blinds,
books, lamp shades
and shelves.
Intelli-Sense
When the Intelli-Sense
lights up, it means that the dust cup is
full, the HEPA filter, non-woven pre-filter
or debris screen need cleaning. You
must empty the dust from the dust cup
and clean the HEPA filter, non-woven
pre-filter, or debris screen.
Also check the hose and attachments to
see if they are blocked with any debris.
If they are, unblock them.
5
Fig. 6
TM Filter Monitor
TM Filter Monitor